Off-Road Vehicles / 4 min read

Jeep Gladiator Off-Road Field Guide

Identify your Gladiator’s transfer case, axle controls and bed hardware, then plan an easy trail day. Includes U.S. 2024 Willys, Mojave and Rubicon examples.

By 4x4Outdoors · Research-based guide · Reviewed · Our approach

Illustrative image of a gray-green Jeep Gladiator with an open bed at a gravel turnout
Illustrative editorial image. This guide draws on published research.

Identify your Gladiator

Start with the model year, trim and transmission. Check the transfer-case selector and match it to the section of your owner’s manual. Look in the 5-foot bed for the original Trail Rail System, a liner, a tonneau or an aftermarket rack. On a used truck, also check for changes to the suspension, tires or spare.

What varies on a 2024 U.S. Gladiator

  • Willys. Jeep lists part-time Command-Trac four-wheel drive, a locking rear differential and Off-Road+. Check the manual for the surfaces and conditions where each mode or lock is permitted.
  • Mojave. Jeep equips it with a rear locker, FOX internal-bypass shocks and front hydraulic jounce bumpers. Mojave X adds a full-time transfer case. Read the actual shift pattern before choosing a mode.
  • Rubicon. Jeep lists Rock-Trac, front and rear lockers and an electronic front sway-bar disconnect. The manual shows different selectors for part-time and full-time systems. Check whether your selector has 4H AUTO and which settings apply to the road ahead.

Prepare for an easy trail day

  • Check current route access and conditions with the land manager. Give your pickup room in tight turns and choose a turnaround before a steep dip, shelf or ledge where the bed or rear bumper could catch.
  • Locate the spare, jack and wheel tools. Make sure you can reach them with the bed packed and any hitch carrier in place. Use the tire and loading label and the owner’s manual to check the tires and spare.
  • Count passengers, the rack and its hardware, and all cargo against the truck’s load limits. Secure loose gear at appropriate anchors. Check that your load leaves the tailgate and driver’s view usable.
  • Stop in a safe, level spot before pavement. Inspect the tires and visible underside, confirm cargo restraints are tight, and return the applicable transfer-case, locker and sway-bar controls to the road settings in your manual.

Check bed hardware and clearance

  • The optional factory Trail Rail Cargo Management Group has three bed rails and movable cargo anchors. Look for the rail across the front of the bed as well as both side rails. Match the rack part number to your rail system, cover and liner.
  • Use the rack’s mounting instructions to check the fit around the tailgate, cab, lights and camera. Check bed access with the gear you plan to carry, especially if a rack crossbar spans the loading area.

Sources & further reading

These sources support the factual reference points in this guide. Practical comparisons and packing suggestions are editorial guidance.