Off-Road Vehicles / 3 min read

Bed Racks for a 2024 Toyota Tacoma Short Bed

Compare three exact bed-rack part numbers for a U.S. 2024 Tacoma TRD Off-Road Double Cab with a 5-foot bed and factory rails.

By 4x4Outdoors · Research-based guide · Reviewed · Our approach

Reviewed truck

U.S. 2024 Toyota Tacoma TRD Off-Road · Double Cab · 5-foot bed · Generation 4

Start with an uncovered bed and intact factory rails. Identify the front and side rails and any liner, cover, or factory rack before choosing a part.

2024 Toyota Tacoma brochure

Compare three verified part numbers

Scroll across to compare rack setups.

Part numbers, mounting, clearance and load limits for the reviewed vehicle
Rack system Cali Raised LED Low Profile Overland Bed Rack Leitner Designs ACS FORGED with sliding rear bar RealTruck Ascend Modular Truck Rack
Part numbers CR405300-4GTT5A-1744RT298507
Required adapters and hardware No separate rack adapter listed.Tacoma brackets are required. Confirm kit contents.No separate rack adapter listed.
Mounting method Bolts to factory side rails. No drilling.Bolts to factory side rails and rear bed mounts.Brackets and T-nuts use front and side rails.
Clearance and restrictions No tonneau. Measure clearance below the bars.Remove a drop-in liner. Check the sliding bar’s travel.Check camera clearance and rack brake-light visibility.
Vehicle load limit Use the door-label payload and axle ratings. Count occupants, the rack, accessories, cargo and any trailer tongue weight.
Rack load limit 400 lb dynamic · 750 lb parked, manufacturer recommendations. 800 lb on-road · 400 lb off-road · 1,400 lb parked. Rating source for Leitner Designs ACS FORGED with sliding rear bar 500 lb dynamic · 1,200 lb parked.

Use the lowest applicable vehicle, rack and accessory limit for your driving conditions. Select a rack name for its fitment sources and details.

Cali Raised LED

Low Profile Overland Bed Rack

Part number
CR4053
Mounting
Attaches to the factory side rails with the supplied hardware. Cali Raised specifies a bolt-on installation without drilling.
Before ordering
Choose Short Bed Low Profile in the listing. Measure cargo clearance below the crossbars. The manufacturer excludes tonneau covers.

Leitner Designs

ACS FORGED with sliding rear bar

Part number
00-4GTT5A-1744
Mounting
Leitner’s fourth-generation instructions use the factory side rails and rear bed bolts with Tacoma-specific brackets.
Before ordering
The sliding rear bar can open up loading space. Leitner calls for removing a drop-in plastic liner before installation. Confirm the sliding-bar model when ordering.

RealTruck

Ascend Modular Truck Rack

Part number
RT298507
Mounting
RealTruck’s instructions use brackets and T-nuts in the front and side bed rails. Confirm the front rail is present as well as both side rails.
Before ordering
This rack has side accessory panels and an integrated high-mounted brake light. Review the lighting connection and check camera clearance before ordering.

Check the whole setup before buying

  • Send the exact part number and photos of your rails and installed accessories to the rack maker if your truck differs from the configuration above.
  • Measure clearance for the cab, tailgate, cargo and any tent or bike mount. Verify that the rack and its load clear the lights and cameras you use.
  • Check the truck’s payload and axle limits with passengers, rack, mounts and cargo on board. Use the applicable rack and accessory limits for driving on pavement, driving off-road, and parking with a load.