Off-Road Vehicles / 3 min read

Bed Racks for a 2024 Ford Ranger 5-Foot Bed

Compare three verified bed-rack part numbers for a U.S. 2024 Ford Ranger XLT FX4 SuperCrew with an uncovered 5-foot bed.

By 4x4Outdoors · Research-based guide · Reviewed · Our approach

Reviewed truck

U.S. 2024 Ford Ranger XLT FX4 · SuperCrew · 5-foot bed · 2024 redesign

The reviewed truck is a 2.3-liter EcoBoost 4x4 with an uncovered factory bed. Check that the structural mounting points are intact and clear of a tonneau, cap, accessory cargo rails or liner hardware. Ford warns against clamping directly to the plastic rail trim. Ford’s accessory guidance calls for load-box reinforcement for accessories extending above the bed rails and weighing more than 88 lb (40 kg). Confirm required reinforcement for your truck with Ford and verify compatibility with the rack maker.

Ford 2024 Ranger configurations · Ford structural bed mounting guidance · Ford non-Raptor load-box reinforcement kit

Compare three verified part numbers

Scroll across to compare rack setups.

Part numbers, mounting, clearance and load limits for the reviewed vehicle
Rack system ADARAC by Agri-Cover Aluminum M-Series, Black ADARAC by Agri-Cover Aluminum Pro Series, Black Putco Venture TEC Rack
Part numbers F4010102F2010102184800
Required adapters and hardware No separate rack adapter listed.No separate rack adapter listed.No separate rack adapter listed.
Mounting method Bolts through factory bed access openings with alignment plates.Rails fasten at the factory bed access openings.No-drill stake-pocket mount. Confirm structural attachment.
Clearance and restrictions Short uprights. Check clearance for tall cargo.Measure loaded height with the tall upright setup.Check the spacing and position for accessory mounts.
Vehicle load limit Use the door-label payload and axle ratings. Ford calls for load-box reinforcement for above-rail accessories weighing over 88 lb (40 kg). Confirm the VN1WZ-2627726-A non-Raptor kit with Ford and the rack maker.
Rack load limit 500 lb on-road · 400 lb off-road · 1,000 lb parked, evenly distributed. Rating source for ADARAC by Agri-Cover Aluminum M-Series, Black 500 lb on-road · 400 lb off-road · 1,000 lb parked, evenly distributed. Rating source for ADARAC by Agri-Cover Aluminum Pro Series, Black 600 lb dynamic · 300 lb off-road dynamic · 1,000 lb parked. Rating source for Putco Venture TEC Rack

Use the lowest applicable vehicle, rack and accessory limit for your driving conditions. Select a rack name for its fitment sources and details.

ADARAC by Agri-Cover

Aluminum M-Series, Black

Part number
F4010102
Mounting
The side rails bolt in at the factory bed access openings. Agri-Cover’s Ranger instructions use alignment plates and call for slits in the supplied rail seal at the bolt locations.
Before ordering
Short uprights keep the crossbars within easier reach from the ground. Measure under-bar clearance if you store a cooler or tall cases in the bed.

ADARAC by Agri-Cover

Aluminum Pro Series, Black

Part number
F2010102
Mounting
The rack’s rails also fasten at the factory bed access openings. Use the Ranger-specific rail instructions together with the standard Pro Series instructions.
Before ordering
Tall vertical uprights leave more room below the bars for loading the bed. Measure overall height with cargo before using garages or routes with low branches.

Putco

Venture TEC Rack

Part number
184800
Mounting
Putco lists a no-drill stake-pocket installation for the Ranger short bed. Confirm with Putco that the hardware supplied for the 2024 bed attaches at Ford’s structural mounting points.
Before ordering
The frame has T-slots for compatible accessories. Check the attachment position and spacing for your gear. Putco sells additional top crossbars separately.

Check the whole setup before buying

  • Send the exact part number and photos of your rails and installed accessories to the rack maker if your truck differs from the configuration above.
  • Measure clearance for the cab, tailgate, cargo and any tent or bike mount. Verify that the rack and its load clear the lights and cameras you use.
  • Check the truck’s payload and axle limits with passengers, rack, mounts and cargo on board. Use the applicable rack and accessory limits for driving on pavement, driving off-road, and parking with a load.